Yamaha YZF-R6T Supplementary Service Manual page 22

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Upper or lower position relation between the left
handlebar switch lead, right handlebar switch lead
and radiator fan motor lead (right) is no object.
Do not catch the coupler when the air filter case is
assembled.
Clamp the wire harness, left handlebar switch
lead, right handlebar switch lead, main switch
lead and radiator fan motor lead (right). Match
the taping positions of three leads except the
wire harness. Point the tip of the clamp to the
front side of the vehicle.
Sealing set of the cover can be either upper or
lower against the frame lower end. However, it
should not be caught.
To the main switch lead coupler
email: info@motomatrix.co.uk
CABLE ROUTING
Point the tip of the plastic locking tie to the rear
side of the vehicle.
To the fuse box and fan motor relay
Pass the throttle cables over the cover 2.
Branching leads to the fuse box and radiator fan
motor relay shall pass through the guide section
of the cover 2 under the wire harness and then
to the outside of the frame.
Clamp the wire harness, main switch lead
branch line, radiator fan motor lead (left), radia-
tor fan motor lead (right).
Tip of the plastic locking tie should point to the
downward outside of the vehicle.
Branching harness from the wire harness.
Use the plastic locking tie to clamp the starter
motor lead at the protector section.
15
SPEC