Yamaha YZF-R6T Supplementary Service Manual page 25

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Insert it to the back end of the rib in the battery box
assembly.
The 20 mm (0.79 in) knob should be within this
range.
Pass the turn signal lead by the outside of the right
side attaching boss of the tail / brake light.
Connect the turn signal light lead couplers (two
leads).
Pass the turn signal light and license light leads
between the rear side ribs of the battery box
assembly and to the rear part of the vehicle.
Connect the license light leads (two leads).
Route the branching lead to the license light
behind the tail / brake light left side attaching boss.
Route the tail / brake light lead under the projection
part.
email: info@motomatrix.co.uk
CABLE ROUTING
Route the tail / brake light lead above the projection
part.
There should be no remarkable difference
between the tension on right and left bands.
Point the tool kit opening to the rear side of the
vehicle.
Connect the tail / brake light lead coupler.
Make sure that the hooks (four positions) of the
battery box assembly catch the upper surface.
(They should not run on the side face.)
When assembling ECU, make sure that the pawls
of the battery box assembly catch.
Route the fuse box lead under the ECU connection
coupler.
Install the wrapping clamp of the wire harness to
the hole of the battery box assembly.
18
SPEC