Installing The Steering Head - Yamaha YZF-R6T Supplementary Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk
STEERING HEAD
3. Replace:
S bearings
S bearing races
a. Remove the bearing races 1 from the steer-
ing head pipe with a long rod 2 and hammer.
b. Remove the bearing race 3 from the under
bracket with a floor chisel 4 and hammer.
c. Install a new rubber seal and new bearing
races.
CAUTION:
If the bearing race is not installed properly,
the steering head pipe could be damaged.
NOTE:
S Always replace the bearings and bearing
races as a set.
S Whenever the steering head is disassembled,
replace the rubber seal.
4. Check:
S upper bracket
S under bracket
(along with the steering stem)
Bends/cracks/damage ! Replace.
EAS00683

INSTALLING THE STEERING HEAD

1. Lubricate:
S upper bearing
S lower bearing
S bearing races
Recommended lubricant
Lithium-soap-based grease
2. Install:
S lower ring nut 1
S rubber washer 2
S upper ring nut 3
S lock washer 4
Refer to "CHECKING THE STEERING
HEAD" in chapter 3.
4-66
CHAS