Yamaha YZF-R6T Supplementary Service Manual page 396

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk
CONNECTING RODS AND PISTONS
EAS00393
REMOVING THE CONNECTING RODS AND
PISTONS
The following procedure applies to all of the
connecting rods and pistons.
1. Remove:
NOTE:
Identify the position of each big end bearing so
that it can be reinstalled in its original place.
2. Remove:
Do not use a hammer to drive the piston pin
out.
NOTE:
S For reference during installation, put identifica-
S Before removing the piston pin, deburr the pis-
3. Remove:
NOTE:
When removing a piston ring, open the end gap
with your fingers and lift the other side of the ring
over the piston crown.
5-67
S connecting rod cap 1
S big end bearings
S piston pin clips 1
S piston pin 2
S piston 3
CAUTION:
tion marks on the piston crown.
ton pin clip groove and the piston pin bore
area. If both areas are debarred and the piston
pin is still difficult to remove, remove it with the
piston pin puller set 4 .
Piston pin puller set
90890-01304, YU-01304
S top ring
S 2nd ring
S oil ring
ENG