Yamaha YZF-R6T Supplementary Service Manual page 181

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Battery
1
Battery positive lead
2
Starter relay
3
Turn signal relay
4
Pressure sensor
5
Tail/ brake light
6
Tool kit
7
Starting circuit cut-off relay
8
Battery box
9
ECU
10
Wire harness
11
Battery negative lead
12
Battery band
13
email: info@motomatrix.co.uk
CABLE ROUTING
A Push the starter motor lead in the clamping sections
(two points) or the battery box assembly and secure
it.
B Fit the plastic cover in the starter relay after the
flange bolts are installed.
C Make sure to clamp the wire harness. (Tighten it un-
til the clamp latchet stops.)
D Install to the deepest position of the rib of the battery
box assembly.
E When installing the ECU, make sure to hook the
pawls of the battery box assembly (at four points).
F Hook of the battery box assembly shall hook on the
upper face of the fuse box. (It should not be put on
the side face.)
G Install the pin of the battery box assembly to its
base.
2-47
SPEC