Assembling And Installing The Rear Brake Caliper - Yamaha YZF-R6T Supplementary Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk
FRONT AND REAR BRAKES
ASSEMBLING AND INSTALLING THE
REAR BRAKE CALIPER
WARNING
S Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
S Never use solvents on internal brake com-
ponents as they will cause the piston seals
to swell and distort.
S Whenever a brake caliper is disassembled,
replace the brake caliper piston seals.
Recommended brake fluid
1. Install:
S brake caliper 1
S brake pad pin
S screw plug
S copper washers
S brake hose 2
S union bolt 3
WARNING
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
"CABLE ROUTING".
CAUTION:
When installing the brake hose onto the
brake caliper, make sure that the brake pipe
a touches the projection b on the brake
caliper.
2. Fill:
S brake fluid reservoir
(with the specified amount of the recom-
mended brake fluid)
Recommended brake fluid
4-43
CHAS
DOT 4
(front)
28 Nm (2.8 mSkg, 20 ftSlb)
(rear)
23 Nm (2.3 mSkg, 17 ftSlb)
New
30 Nm (3.0 mSkg, 22 ftSlb)
DOT 4