Tightening Torques; Engine Tightening Torques; Chassis Tightening Torques - Yamaha YZF-R6T Supplementary Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys

TIGHTENING TORQUES

ENGINE TIGHTENING TORQUES

Item
Clutch boss
Cylinder identification sensor

CHASSIS TIGHTENING TORQUES

Handlebar and front fork
Front fender and front fork
Rear brake master cylinder and footrest bracket
Front brake caliper and front fork
Front master cylinder bleed screw
Brake caliper bleed screw
Front wheel axle pinch bolt
email: info@motomatrix.co.uk
TIGHTENING TORQUES
Fastener
Nut
Bolt
Item
Tightening torque
Thread
Q'ty
size
Nm
M20 1 90
M6 1 7.5
Tightening torque
Thread
size
Nm m•kg
M8 32 3.2
M6 6 0.6
M8 13 1.3
M10 35 3.5
M8 6 0.6
M8 5 0.5
M8 21 2.1
NOTE: NOTE:
1. Insert the front wheel axle from the right
side and tighten it with the flange bolt from
the left side to 91 Nm (9.1 m•kg, 66 ft•lb).
2. In the order from the pinch bolt
→ pinch bolt
bolt
21 Nm (2.1 m•kg, 15 ft•lb) without perform-
ing temporary tightening.
3. Check that the end face of the axle head
and the end face of the fork side are flush-
mounted. If they are out of alignment, make
sure to fit them by adding the external force
by hand or with a plastic hammer, etc.
If the end face of the axle is not parallel to
the end face of the fork, align them so that
one point of the axle circumference is posi-
tioned on the end face of the fork.
At this stage, it can be accepted if the end
face of the axle becomes partially concave
to the end face of the fork.
4. In the order from the pinch bolt
→ pinch bolt
bolt
21 Nm (2.1 m•kg, 15 ft•lb) without perform-
ing temporary tightening.
5
SPEC
Remarks
m•kg ft•lb
9.0 65 Use a lock
washer
0.75 5.4
Yamaha bond No.1215
Remarks
ft•lb
2.3
4.3
9.4
25
4.3
3.6
15 See NOTE
→ pinch
, tighten each bolt to
→ pinch
, tighten each bolt to