Software Interface Sample: Arclist Ver. 2.06 - Bryce 5K-LE Owner's Manual

Software interface sample:
The Arclist program must be configured for use by the Bryce BOS
and output type selection.
You must first identify the Bryce BOS 5K-LE printer.
Run Arclist program called CONFIG.
Choose PRINTER from menu, then choose CUSTOM from menu, then type Bryce BOS 5K-LE as
printer. When this information is entered, a PORT menu will be displayed.
Select appropriate port, and characteristics if using a serial port.
NOTE: The BOS 5K-LE must have the same port characteristics as the computer port.
All special entries (line feed, fonts, etc.) should be left blank.
Select SAVE from menu, then choose OKAY from menu.
Select QUIT from menu, then choose SAVE from menu.
Next identify the address format.
Run ARCLIST.
Select LABELS from menu, then choose PRINT from menu, use the arrow keys to select a format.
Select Bryce BOS 5K-LE .
Enter data according to the table below.
Title: Bryce BOS 5K-LE
Label Type: envelope
Pitch: pica
Font: Normal
Line Feed: Normal
Left Margin: 0
Label width in chars: 42
Lines per label: 8
Top Margin: 0
Labels Down: N/A
Lines Between Labels: N/A
Labels Across: N/A
Space Between Labels: N/A
Criteria: All
Index: Record
Order: Ascending
Printer: Bryce BOS 10K
Select ALL or Nth
Select INDEX or PRESORT
Select DEFAULT from Printer Menu
Select NON-STOP or PAUSE
Select GO from Printer menu
Print Mailing Labels
NOTE: To pause the program while printing, press ESC on the Computer Keyboard instead of taking the
BOS 5K-LE Off Line.
Revision A
Appendix F Printing with Software
ARCLIST ver. 2.06
5K-LE OWNERS MANUAL
P/N 90-00852-001
5K-LE
in terms of both printer type selection
Section F - 7