Setting Up The Printer; Choosing A Good Location For The Printer; Removing Protective Materials - Bryce 5K-LE Owner's Manual

The following environmental considerations must be kept in
mind when selecting a location for the Address Printer. Doing
otherwise may affect the operation and performance of the
Address Printer.
1. Place the printer close enough to the computer for the
parallel or serial cable to reach.
2. Place the printer on a flat, stable surface.
3. Use a grounded, dedicated outlet for the printer only.
Note: Do not use an adapter plug.
4. Avoid locations near direct sunlight, excessive heat,
high humidity, moisture, or dust.
5. Keep the entire system away from large motors or
other appliances that might disturb the power supply or
create potential interference.
The printer is protected during shipping by a sheet of
corrugated cardboard around the Print Head Holder Assembly.
1. Raise the Front Door to gain access to the interior.
2. Remove the corrugated cardboard. Be careful not to
grab or pull on the ribbon in the back of the Print Head
Holder Assembly.
Revision A 5K-LE OWNERS MANUAL
P/N 90-00852-001

Setting up the Printer

Choosing a
Good Location
for the Printer
Note
: AB switches are
not recommended for
operation with this
printer.
Removing
Protective
Materials
Section 3 - 1