Cleaning The Sensor Assembly; Cleaning The Right & Left Hand Slider Rollers; Cleaning The Floor And Covers - Bryce 5K-LE Owner's Manual

With use, a film and/or dust builds up on the eye of the sensor
causing misfeeds of media. Periodically use compressed air to
blow dust from the sensors. For caked on dust use a Q-tip to
remove the dust from the eye of the sensor.
When the Right and Left Hand Slider Rollers are adjusted
over the area where the address is printed the ink will get
transferred from the media onto the rollers and the surface of
the sliders. Use water to dampen a soft cloth to remove the ink
from the rollers and sliders.
Ink will get sprayed on the Floor Assembly from all the
purging, setting up and printing records, etc. Eventually an
enough ink will accumulate on top of the Floor Assembly to
give the floor a black glossy sheen and the back of the media
will start to pick up some of the ink as well. Use water to
dampen a soft cotton cloth to remove the ink from the Floor
Assembly.
Revision A
Cleaning and Maintaining the Printer
5K-LE OWNERS MANUAL
P/N 90-00852-001
Cleaning the
Sensor Assembly
Cleaning the Right
and Left Hand
Slider Rollers
Note
: The lower half of
the Sensor is seen
through the hole in the
floor.
Cleaning
the Floor
and Covers
Section 5 - 2