Software Interface Sample: Arclist Ver. 2.06 - Bryce 9K-L User Manual

Software interface sample:
The Arclist program must be configured for use by the Bryce BOS 9K-L in terms of both printer type selection and
output type selection.
You must first identify the Bryce BOS 9K-L printer.
Run Arclist program called CONFIG.
Choose PRINTER from menu, then choose CUSTOM from menu, then type Bryce BOS 9KL as printer.
When this information is entered, a PORT menu will be displayed.
Select appropriate port, and characteristics if using a serial port.
NOTE: The BOS 9K-L must have the same port characteristics as the computer port.
All special entries (line feed, fonts, etc.) should be left blank.
Select SAVE from menu, then choose OKAY from menu.
Select QUIT from menu, then choose SAVE from menu.
Next identify the address format.
Run ARCLIST.
Select LABELS from menu, then choose PRINT from menu, use the arrow keys to select a format.
Select Bryce BOS 9KL.
Enter data according to the table below.
Title: Bryce BOS 9KL
Label Type: envelope
Pitch: pica
Font: Normal
Line Feed: Normal
Left Margin: 0
Label width in chars: 42
Lines per label: 8
Top Margin: 0
Labels Down: N/A
Lines Between Labels: N/A
Labels Across: N/A
Space Between Labels: N/A
Criteria: All
Index: Record
Order: Ascending
Printer: Bryce BOS 10K
Select ALL or Nth
Select INDEX or PRESORT
Select DEFAULT from Printer Menu
Select NON-STOP or PAUSE
Select GO from Printer menu
Print Mailing Labels
NOTE: To pause program while printing, press ESC on Computer Keyboard instead of turning off the
On-Line light on the BOS 9K-L.
Revision A
Appendix F Printing with Software
ARCLIST ver. 2.06
9K-L USERS MANUAL
P/N 90-00860-001
Section F - 8