Software Interface Sample: Dbase Iv Ver 1.0 - Bryce 5K-LE Owner's Manual

Software Interface sample:
Upon entering dBASE, the dBASE Control Panel will be displayed.
To Create a Label, move cursor to the labels column and select <create>.
A label will be displayed on the screen.
Press ALT & D, to pull down the Dimensions menu, the following settings should be entered;
Width of label
Height of label
Indentation
Lines between labels
Space between columns
Columns of labels
Press ESC
Add fields to label using the instructions at the bottom of the screen.
Once you have completed your layout, press ALT & L to pull down the Layout menu and
select;
Save this label design.
When this label format is saved, it will be displayed as a file under the labels column in the
control panel.
To Print labels;
Activate a data file;
Select the label file you created under the labels column;
Follow menu directions to print.
NOTE: dBase IV does a CR & LF before each address, therefore you must do the
following:
IF SEVEN LINE ADDRESS, DO A FF BEFORE THE START OF THE NAME,
Example
CHR(12)+NAME
Revision A
dBASE IV ver 1.0
45
Set to the number of lines in your address
0
1
1
1
<CR> <LF>
5K-LE OWNERS MANUAL
P/N 90-00852-001
Appendix F Printing with Software
Section F - 11