Fine Tuning The Adjustment Lever - Bryce 5K-LE Owner's Manual

4. Put the media into the bin. Start with a few pieces to
get the proper contour. The media stack should be
"shingled" when loaded into the input bin with flap
away from the feed roller and facing downward. Add
several more pieces. Keep adding to the stack until the
bin is full of media.
Different sizes and types of media call for unique settings for
the Print Head Holder Assembly. To accommodate different
sizes of media the Adjustment Lever increases or decreases
the distance of the ink jet cartridge from the media. This gives
the printer the ability to adapt to different types of media.
Proper use of the lever results in clean crisp print. Use the
following steps as a general guideline to get the best quality
possible with most types of media:
1. Load the media that is going to be used for a job.
2. Raise the Adjustment Lever to the fully opened
position. Reference the Figure below.
3. Press the [Test Env.] button down. The printer feeds
and prints a test piece.
4. If the print is indistinct, hazy or too light, lower the
lever. Keep lowering the lever and pressing the [Test
Env.] button until the best print quality is found.
Revision A 5K-LE OWNERS MANUAL
P/N 90-00852-001
Trying Out the Printer
Fine Tuning the
Adjustment Lever
Note
: If the print
smudges the ink
cartridge is touching the
media. Raise up the
Adjustment Lever until
it stops.
Section 4 - 11