Wire Form Center Adjustment - Bryce 5K-LE Owner's Manual

• Wire Form Center Adjustment to eliminate
skewing of the media and print.
• Wire Form Height Adjustment to allow the printer
to feed media of varying density. Example: Rigid
media is set low, light weight media is set high.
• Wire Form Ramp Adjustment improves the
feeding of media by distributing the weight of the
media stack onto the feed roller.
The Feed Carriage Assembly needs to be adjusted with the
Wire Form Assembly.
1. Place a piece of the media in the bin area against the
Rear Support Plate Assembly.
2. Unlock Feed Carriage assembly by pushing locking
lever down
Adjust Feed Carriage
3. Slide Feed Carriage Assembly to the center of the
media.
4. Pull lever up to lock Feed Carriage Assembly in place.
Revision A 5K-LE OWNERS MANUAL
P/N 90-00852-001
Trying Out the Printer
Wire Form
Center
Adjustment
Section 4 - 8