Bryce 5K-LE Owner's Manual page 50

SYMPTOM
Framing Error
(Error Message)
Parity Error
(Error Message)
Parallel Interface, printer is
not printing (Printer
Halted)
Serial Interface, printer is
not printing
Optional Fonts not
functioning
Address Too High
(Error Message)
Address Too Low
(Error Message)
Revision A
CAUSE
Incorrect Word Length /
Parity / Baud Rate
Incorrect Parity setting
Bad data sent
Bad communications Cable
Bad main processor board
Centronic (Parallel) Cable
over maximum length
Incorrect Software Driver
Bad data sent
Bad communications Cable
Bad main processor board
RS232 -C (Serial) over
maximum length
Incorrect Software Driver
Font Cartridge not installed
correctly
Software Margin incorrect
Software Margin incorrect
5K-LE USERS MANUAL
P/N 90-00852-001
Troubleshooting and Diagnostics
SOLUTION
Turn printer off then back on and send data again.
Reset settings for Baud rate in printer or
computer.
Turn printer off then back on and send data again.
Reset Parity rate in printer or computer.
Turn printer off, then turn printer on and send
again.
Replace parallel cable, maximum length 10 feet
(304.8 cm)
Call Service Representative.
Replace parallel cable, maximum length 10 feet
(304.8 cm)
Typical dumb printer interface (TTY, Teletype,
DOS text printer, Generic printer) or HP Laserjet
series II, W700 or 9K-L.
Turn printer off, then turn printer on and send
again.
Replace serial cable, maximum length 15 feet
(457.2 cm)
Call Service Representative.
Replace serial cable, maximum length 15 feet
(457.2 cm)
Typical dumb printer interface (TTY, Teletype,
DOS text printer, Generic printer) HP Laserjet
series II, W700 or 9K-L.
Verify the Font Cartridge label is facing the
operator.
Verify the Font Cartridge is inserted all the way
into the Font Cartridge Slot.
Top Line of the Address is above the edge of the
media. Move the location of the address down.
The Address is below the Bottom edge of the
media. The bottom edge margin must be
increased.
Section 7 - 4