Setting The Sliding Fence - Bryce 5K-LE Owner's Manual

Recheck your setup and adjustments:
• Is the feed gap set?
• Is the Wire Form in the center of the media?
• Is the Wire Form at a good height?
• Is the Feed Ramp beneath the edge of the media?
Position the Sliding Fence before stacking the bin area with
media. The fence has to be close enough to the media to keep
it from going in at an angle and loose enough for the media to
drop down to the Feed Rollers. To properly position the fence:
1. Place a handful of the prepared media in the input bin
area.
2. Square the stack against the wall of the Rear Support
Plate Assembly and the H-Block Assemblies.
3. Push the Sliding Fence in near the media. Leave a gap
of 1/16 of a inch [1.587 mm] or the thickness of one
or two #10 envelopes. This size of gap places the fence
close enough to prevent pieces from twisting and
turning as they enter the printer, and the fence won't
be to close to the media to trap and restrain the pieces
between the fence and the wall of the Rear Support
Plate Assembly. This would hinder the media from
being fed into the printer.
Revision A 5K-LE OWNERS MANUAL
P/N 90-00852-001
Trying Out the Printer
Setting the
Sliding Fence
Section 4 - 10