Setup With #10 Envelopes; Wire Form Adjustments - Bryce 5K-LE Owner's Manual

followed the preceding steps and are experiencing feeding
problem using post cards or stuffed media try the following:
Post cards (.003" [0.0762 mm] thickness) - set a smaller gap
between the H-Block Assemblies and the Feed Rollers. Try
using a sheet of copy paper to set the feed gap.
Stuffed Media - set a larger gap between the separator blocks
and the feed roller. Try adding two or three, number ten (# 10)
envelopes, on top of the media before setting the separators.
Perform the preceding steps for setting the feed gap using #10
envelopes. Notice that only two of the H-Block Assemblies
completely rest on the envelope. The third H-Block has one
separator finger on the envelope and one on the feed roller.
1. Take Sliding Fence off and remove out of the way.
2. Fit a second envelope between the other half of the H-
Block Assembly and the Feed Roller.
3. Loosen the H Block Knob to let the H-Block Assembly
fall freely onto the envelope. Verify envelopes are
between all the Separators Fingers and the Feed
Rollers.
4. Lock in place by tightening the H Block Knob.
5. The Input Bin can now be filled with #10 envelopes
for printing. The stack of envelopes should be
"shingled" or layered with the piece on top partially
covering the piece below it like shingles on a roof.
Load into the input bin with flap away from the feed
roller and facing downward. Start with just a few
envelopes to start the stack and get the angled contour
of the bin area, then add several more pieces. Then add
the remainder of the stack.
The Wire Form assembly supports the media stacked in the
input bin area and redistributes the weight of the media to
assist in the feeding of the media. The Wire Form assembly
has three basic adjustments.
Revision A 5K-LE OWNERS MANUAL
P/N 90-00852-001
Trying Out the Printer
Setup with
#10
Envelopes
Wire Form
Adjustments
Section 4 - 7