Software Setup - Bryce 5K-LE Owner's Manual

Software Setup

This section will help in setting up the Address Printer to run programs in Windows 3.1 and
DOS. Some assistance is given for use on the Apple and Macintosh. If you are using Windows
95 / 98 or Window NT 4.0 use the Bryce driver installation disk that is included in the
accessories kit.
Generic Software Driver Information
Most software packages allow you to select or setup a printer driver. Use one of the
following printer drivers.
Dumb Printer
Generic Printer
Typewriter
Plain Vanilla
Teletype
TTYCRLF Printer
TTYCR Printer
turned on)
If none of these choices are available one of the following may work:
HP Laserjet Series II or any Laserjet II listed (excluding Postscript)
HP Laserjet 4
DOS Text Printer
The MODE COMMAND must be set as stated below!!!
Type the MODE command at the DOS prompt or add the MODE command to the
AUTOEXEC.BAT file. The AUTOEXEC.BAT will load the command when the
computer is first booted up.
Example:
When printing to the parallel port load MODE LPT1:,,P
When printing to the serial port load MODE COM1:9600,N,8,1,P
(NOTE: The printer ports or parameter settings may vary from the preceding
MODE command examples. If using DOS version 5.0, a ,,B may be substituted for
the ,,P)
Revision A
Appendix F Printing with Software
(This requires the Setup Menu CR = CR + LF option to be
5K-LE OWNERS MANUAL
P/N 90-00852-001
Section F - 2