Preparing The Media - Bryce 5K-LE Owner's Manual

Recheck that all the necessary components of the printer are
installed.
• Is the Wire Form Assembly installed?
• Is the Sliding Fence installed?
• Is the printer plugged into a power outlet?
• Does the printer have an Ink Jet Cartridge installed?
• Is the printer connected to the computer?
Now that all the parts of the printer are installed the printer
needs to be adjusted to work with the media. To avoid
problems of misfeeding and jams the media must also be made
ready for the printer.
Use the following steps to make the media ready for printing:
1. Take a manageable pile of media and while holding
them (as shown in the following illustration as
reference A), "fan" all sides of the media to make sure
that each piece of media is free from one another.
2. Square the pile against the table top, assuring a square
pile on all sides. (Reference B in following illustration)
This will also allow media to settle toward the bottom
of a stuffed envelope and will increase the feeding
capabilities of the printer.
Fan All Sides of Media
Revision A
Square Media
5K-LE OWNERS MANUAL
P/N 90-00852-001
Trying Out the Printer

Preparing the Media

Note
: Maximum
thickness is 1/16"
(1.587mm) for the 5K-LE.
Section 4 - 4