Troubleshooting And Diagnostics - Bryce 5K-LE Owner's Manual

SYMPTOM
Print Quality Problems
(No print)
Non Uniform Print Quality
Ink Streaking on Media
Ink Print Quality is not
sharp
Print is Skewed
(Skew Specification +/- 2
1/2 degrees of bottom
edge.)
Print Quality Problems
(Gray Print)
Revision A
CAUSE
Ink Jet Cartridge problems
Print Head Holder broken
Print Head Holder broken
Print Head Adjustment
Lever set too low
Ink on Exit Slider Rollers
Print Head Adjustment
Lever set too high
Media unsuitable
Separators ("H" blocks) not
set correctly
Wire Form set wrong
Sliding Fence set wrong
Exit Slider Rollers set
wrong
Wiper Assembly bent or
Idler Assembly set wrong
Ink Jet Cartridge empty
5K-LE USERS MANUAL
P/N 90-00852-001

Troubleshooting and Diagnostics

SOLUTION
Purge ink jet cartridge.
Clean cartridge with soft cotton cloth and water.
Change to a known good cartridge.
Call Service Representative.
Call Service Representative.
Lift lever up to raise the Print Head Holder.
Clean Rollers with water to remove ink.
Lower lever down to lower the Print Head Holder
Change to a typical white wove bonded paper
Reset each of the H-Blocks.
Set the Wire Form to the center of the media.
Adjust the fence to within 1/16" (0.16 cm) of the
media.
Adjust exit roller to within 1/4" (6.35 mm) from
outside edges of media.
Replace Wiper Assembly or fix spring tension on
Idler Assembly.
Ink supply too low, Replace Ink Jet Cartridge
Section 7 - 2