Software Setup - Bryce 9K-L User Manual

Software Setup

Generic Software Driver Information
Most software packages allow you to select or setup a printer driver. Use one of the
following printer drivers.
Dumb Printer
Generic Printer
Typewriter
Plain Vanilla
Teletype
TTYCRLF Printer
TTYCR Printer
turned on)
If none of these choices are available one of the following may work:
HP Laserjet Series II or any Laserjet II listed (excluding Postscript)
HP Laserjet 4
DOS Text Printer
Don't forget to set the MODE COMMAND!!!
Type the MODE command at the DOS prompt or add the MODE command to the
AUTOEXEC.BAT file. The AUTOEXEC.BAT will load the command when the
computer is first booted up.
Example:
When printing to the parallel port load MODE LPT1:,,P
When printing to the serial port load MODE COM1:9600,N,8,1,P
(NOTE: The printer ports or parameter settings may vary from the preceding
MODE command examples. If using DOS version 5.0, a ,,B may be substituted for
the ,,P)
Revision A
Appendix F Printing with Software
(This requires the Setup Menu CR = CR + LF option to be
9K-L USERS MANUAL
P/N 90-00860-001
Section F - 2