Communications with the host cannot be performed via the parallel interface.
7
•
Is the parallel interface or auto interface selected in menu level 1?
•
No
Select the parallel interface or auto interface in menu level 1.
•
Yes
Is the host set to the bidirectional communication?
•
Yes
Set the parallel I/F to the bidirectional communication enable state (DISABLE
→ ENABLE) in menu level 2.
Set the parallel I/F to the bidirectional communication disable state (ENABLE →
•
No
DISABLE) in menu level 2.
•
Is the printer recovered?
•
Yes
END
•
No
Is the connector of the parallel interface cable connected to the printer properly?
•
No
Connect the connector of the parallel interface cable to the printer properly.
•
Yes
Is there any defect in the cable (broken or bent pin, broken wire)?
•
Yes
Replace the parallel interface cable.
•
No
Replace the Main board or ask the user to check the hardware and software at the
host side.
Troubleshooting
6 - 32
Service Manual, P/N 59274401
OKIPAGE 16n