Installing A Half-Height Or Full-Height Media Device - HP ProLiant ML370 Generation 4 Reference And Troubleshooting Manual

70 HP ProLiant ML370 Generation 4 Server Reference and Troubleshooting Guide
9. Install the removable media device. ("Installing a half-height or full-height
media device" on page 70)
10. When removable media device installation is complete, reinstall the
following items:
−
−
−
−
−
11. Install other hardware options as needed or reinstall the access panel.
12. Power up the server ("Powering up the server" on page 27).

Installing a half-height or full-height media device

You can install up to two half-height or one full-height removable media devices
in the removable media cage. To install a half-height or full-height media device:
1. Power down the server ("Powering down the server" on page 27).
2. Extend or remove the server from the rack ("Extending the server from the
rack" on page 28).
3. Remove the front bezel door, if necessary.
4. Remove the access panel ("Removing the access panel" on page 30).
5. Access the removable media cage. ("Accessing the removable media cage"
on page 68)
CD-Rom drive, if needed
Center wall
Expansion boards
Processor air baffle
Bezel blanks
NOTE: If the second media bay is populated with an optional drive,
store the extra bezel blank for later use.
NOTE: HP recommends that you remove all bezel blanks to facilitate
drive installation.