Removing The Access Panel - HP ProLiant ML370 Generation 4 Reference And Troubleshooting Manual

30 HP ProLiant ML370 Generation 4 Server Reference and Troubleshooting Guide

Removing the access panel

1. Power down the server if performing a non-hot-plug installation or
maintenance procedure ("Powering down the server" on page 27).
2. Extend or remove the server from the rack ("Extending the server from the
rack" on page 28).
3. Open the front bezel ("Unlocking the front tower bezel" on page 29).
4. Lift up on the hood latch handle and remove the access panel.
After installing hardware options, replace the access panel. Be sure that the panel
is locked into place securely before powering up the server.
WARNING: To reduce the risk of personal injury from hot
surfaces, allow the drives and the internal system components to
cool before touching them.
CAUTION: Do not operate the server for long periods without
the access panel. Operating the server without the access panel results
in improper airflow and improper cooling that can lead to thermal
damage.