Accessing The Removable Media Cage - HP ProLiant ML370 Generation 4 Reference And Troubleshooting Manual

68 HP ProLiant ML370 Generation 4 Server Reference and Troubleshooting Guide

Accessing the removable media cage

The server supports installation of an optional SCSI tape backup drive, internal
two-bay hot-plug SCSI drive cage, or other devices in the removable media area.
1. Power down the server ("Powering down the server" on page 27).
2. Extend or remove the server from the rack ("Extending the server from the
rack" on page 28).
3. Remove the front bezel door, if necessary.
4. Remove the access panel ("Removing the access panel" on page 30).
5. Press and hold the sliding media latch to release the bezel blanks, while
pushing the blanks from behind to remove.
IMPORTANT: HP and Compaq branded SCSI non-hot-plug cables are
terminated. Remove all terminating jumpers from third-party SCSI
devices before installing them in the server.
CAUTION: Always populate each media bay with either a
device or a blank. Proper airflow can only be maintained when the bays
are populated. Unpopulated drive bays can lead to improper cooling and
thermal damage.
NOTE: HP recommends that you move the CD-ROM drive out of the
media cabling area for ease of installation. It is not necessary to
disconnect and remove the CD-ROM drive from the server entirely.