Table of Contents
Advertisement
Removal and Replacement Procedures
To remove the access panel:
1. Power down the server. See "Powering Down the Server" in this chapter.
2. Loosen rear thumbscrew by using the T-15/T-10 Torx screwdriver or the flat screwdriver.
3. Slide the access panel approximately 1.25 cm (0.5 in) toward the rear of the unit and lift
the panel to remove it.
Figure 2-1: Removing the access panel
To replace the access panel, reverse steps 1 through 3.
2-6
HP ProLiant DL320 Generation 3 Server Maintenance and Service Guide
Advertisement
Table of Contents
