7. Install the processor air duct. For instructions, see
Duct" on page
8. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser Assembly" on page
Removing the I/O Expansion Module
To remove the I/O expansion module, follow these steps:
1. Remove the PCI riser assembly. For instructions, see
Assembly" on page
2. Remove the processor air duct. For instructions, see
Duct" on page
3. Disconnect the I/O expansion module from the server board connector and the
standoffs and remove the module out of the server system (see letter "A" in
Figure
4. Remove the standoffs from the server board (see letter "B" in
70
Snap
C
Standoff
B
Standoff
Hole
Server Board
I/O Connector 1
Figure 59. Installing the I/O Expansion Module to the Server System
47.
41.
46.
60).
A
Filler Panels
"Installing the Processor Air
42.
"Removing the PCI Riser
"Removing the Processor Air
Figure
®
Intel
Server System SR1600UR Service Guide
AF002855
60).