Figure 71. Making Cable Connections - Intel SR1600UR Service Manual

a. Connect the hard drive SATA cables from either the server board or the add-in
SATA Conn.
Details
D
b. If you connect the SATA cables from the passive backplane to the add-in card,
Note: Do NOT connect the HBA cable in a system with an active backplane or when
12. Install the processor air duct. For instructions, see
Duct" on page
13. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser Assembly" on page
®
Intel Server System SR1600UR Service Guide
card to the corresponding SATA connectors on the backplane (see letter "D" in
Figure 71 - connection from the server board shown).
D

Figure 71. Making Cable Connections

also install the 3-pin white cable between the HBA connector on the backplane
and the add-in card to enable fault LED control.
using the SATA connectors on the server board to connect the hard drive SATA
cables.
47.
C
A
"Installing the Processor Air
42.
D
SATA Conn.
Detail
USB
Cable
Data
Cable
B
AF002902
81