Hardware Installations and Upgrades
4. If no device will be installed in this location, install a filler panel in this location.
Installing and Removing Intel
Installing Intel
1. Squeeze the sides of the filler panel to disengage it from the server system back panel and
remove it (see letter "A").
2. Position the module over the server board, fit the front of the module into the back panel slot
(see letter "B").
3. Attach the module to the server board connector (see letter "C").
4. Secure the module with the three screws as shown (see letter "D").
Removing Intel
1. Remove the three screws as shown (see letter "A").
2. Remove the module out of the server system (see letter "B").
40
®
I/O Expansion Module
Figure 64. Installing Intel
®
I/O Expansion Module
®
I/O Expansion Module
®
I/O Expansion Module
®
Intel
Server System R2000GZ/GL Service Guide