Installing And Removing The I/O Expansion Module; Installing The I/O Expansion Module - Intel SR1600UR - Server System - 0 MB RAM Service Manual

Installing and Removing the I/O Expansion Module

Installing the I/O Expansion Module

To install the I/O expansion module, follow these steps:
1. Remove the PCI riser assembly. For instructions, see
Assembly" on page
2. Remove the processor air duct. For instructions, see
Duct" on page
3. Squeeze the sides of the I/O expansion module filler panel(s) to disengage it from
the server system back panel and remove it (see letter "A" in
Note: If you are installing an I/O expansion module that uses only one slot, remove the filler
panel only from the slot shown so that the module can be attached to I/O connector 1. Do
not remove the filler panel from the second slot.
4. Attach the standoffs to the server board by pressing into the holes (see letter "B" in
Figure
Note: For the 1-socket expansion module, install the three standoffs shown in gray. For the 2-
socket expansion module, also install the fourth standoff shown in red..
5. Position the I/O expansion module over the server board as shown in
6. First fit the front of the module into the back panel slot(s), and then attach the
module to the server board connector and engage the standoffs (see letter "C" in
Figure
68
41.
46.
59).
59).
"Removing the PCI Riser
"Removing the Processor Air
Figure
®
Intel Server System SR1600UR Service Guide
59).
Figure 59.