Table of Contents
Advertisement
3
Point the arrow at ON using the UP/DOWN key. Select a level from 1 through 7
using the dial, and then press the
meter level, select OFF and then press the
Higher levels require stronger signals to stop scanning.
The display will return to the SCAN mode. Point the arrow at END and then
press the
the
3.1.17 Setting the scanning pause
The scanning pause period for the TIMER option can be set.
1
2
Point the arrow at +Busy Timer and then press the
TF
ENT
3
Set the scanning pause period using the dial or UP/DOWN key, and then press
the
The display will return to the SCAN menu. Point the arrow at END and then
press the
44
Select an S-meter level.
TF
key (Alternatively, you may press the
ENT
TF
key with
shown on the display).
ENT
Note:
If you exit the SCAN menu by pressing the
canceled.
period
Call up the SCAN menu.
Press the
the
the display.
The SCAN menu will appear.
Point the arrow at +CONFIG using the dial or UP/DOWN
key, and then press the
The CONFIG menu will appear. Point the arrow at
3
+SCAN SETUP and then press the
2
1
Call up the BUSY TIMER screen.
key.
Set the scanning pause period.
TF
key (the initial setting is 5s).
ENT
TF
key (Alternatively, you may press the
ENT
shown on the display).
Note:
If you exit the SCAN menu by pressing the
canceled.
TF
key. If you do not want to select any S-
ENT
TF
key (the initial setting is OFF).
ENT
F
key, and then press
SET
key with
shown on
HELP
TF
ENT
key, and then press
F
SKIP
key, the changed setting is
CLR
SCAN MODE
BUS Y T i me r
key.
TF
key.
ENT
u s y T i me r
B
key, and then press the
F
SKIP
key, the changed setting is
CLR
5 s
Advertisement
Table of Contents
