Table of Contents
Advertisement
3.1.11 Selecting the BELL mode
In this mode, when squelch is canceled, the buzzer sounds.
1
2
Point the arrow at ON or OFF using the dial or UP/DOWN key, and then press
the
When squelch is canceled, the buzzer sounds for 10 seconds and
blinking. Pressing the
The display will return to the CONFIG menu. Point the arrow at END and then
press the
the
3.1.12 Changing the initial message
The initial message that appears after the power has been turned ON can be
changed as follows:
1
40
Call up the BELL screen.
Press the
press the
shown on the display.
The BELL menu will appear.
Point the arrow at +CONFIG using the dial or UP/DOWN
key, and then press the
The CONFIG menu will appear. Point the arrow at
3
+BELL and then press the
2
1
Turn the BELL mode ON/OFF.
TF
key (the initial setting is OFF).
ENT
SKIP
CLR
TF
key (Alternatively, you may press the
ENT
TF
key with
shown on the display).
ENT
Note:
If you exit the CONFIG menu by pressing the
is cancelled.
Call up the OPENINGMG screen.
Press the
the
the display.
The menu will appear. Point the
arrow at +CONFIG and then press the
The CONFIG menu will appear. Point the arrow at
+OpeningMG and then press the
3
2
1
F
key, and then
SET
key with
HELP
TF
ENT
key cancels this blinking.
F
key, and then press
SET
key with
shown on
HELP
BEL L
OF F
ON
key.
TF
key.
ENT
starts
key, and then press
F
SKIP
key, the changed setting
CLR
1
L I NE MSG
A BCDE FGH I J K
A L I NCO
TF
key.
ENT
TF
key.
ENT
Advertisement
Table of Contents
