Selecting A Communication Speed - Alinco DJ-X2000 Instruction Manual

When the cloning procedure is finished, the slave unit returns to the normal
screen and the master unit to the CLONE menu.
3
Once the cloning procedure is finished, disconnect the cable from both DJ-
X2000 units. Press the
The slave unit can be used without this operation.

3.1.6 Selecting a communication speed

A communication speed during the cloning procedure or communication with a
personal computer can be selected (the initial setting is 38400 bps).
• To select 38400 bps:
• To select 19200 bps:
• To select 9600 bps:
36
Finish the cloning procedure.
SKIP
CLR
CAUTION: • Do not disconnect the cable, nor turn the power OFF during the
cloning procedure.
• If a cloning error occurs, press the hardware reset key or remove
the battery.
Turn the power ON while holding down the
3
2
1
6
Turn the power ON while holding down the
3
2
1
6
key on the master unit to exit the CLONE menu.
ATT
key.
3
STEP
key.
2