Table of Contents
Advertisement
• Transmission and reception
1
Select the frequency you want to receive.
The frequency can be selected using the dial or UP/DOWN key. However, the
following limitations apply:
Radio type
Frequency range
Frequency step
When
is shown on the display by pressing the
F
increased or decreased in steps of 250 kHz using the dial or UP/DOWN key.
2
Perform transmission.
3
2
1
6
5
4
Note:
• Since the transmission uses only weak signals, no license for an amateur
radio station or the like is required.
• For the same reason, no antenna for weak transmission is connected to the
BNC connector.
NFM only
250.000 MHz to 259.975 MHz
Fixed at 25 kHz
In the TRANCEIVER mode, the
left side of the DJ-X2000 works as the PTT key.
If you speak to the microphone when the PTT key is ON,
the voice can be transmitted at the currently received
frequency.
The status of the PTT key can be selected from ON and
OFF.
key, the frequency can be
SRCH
key located on the
61
Advertisement
Table of Contents
