Table of Contents
Advertisement
3.1.25 CTCSS decoding function
This function is used to receive CTCSS signals. It allows you to receive 38
waves of CTCSS signals and even select the reverse reception. The function is
also applicable to taxi radio.
• Setting the reception of CTCSS signals
Specify the reception frequency of CTCSS signals and turn ON/OFF the
reception.
1
2
Point the arrow at ON using the UP/DOWN key, and then select the reception
frequency of CTCSS signals using the dial.
The range of selectable frequencies is between 76 and 254 Hz (the initial setting
is 88.5 Hz).
If you do not want to receive CTCSS signals, select OFF.
Press the
• Priority order in comparison with the Descrambler and A/B squelch
The CTCSS decoding function cannot be used with the Descrambler or A/B
squelch.
• If the Descrambler or A/B squelch is active, the CTCSS decoding function is
disabled.
• If the Descrambler or A/B squelch is turned ON when the CTCSS decoding
function is active, the CTCSS decoding function is disabled during its use.
52
Note:
Only the NFM type radio can be received as CTCSS signals.
Call up the CTCSS MANUAL screen.
Press the
CTCSS
the
the display.
The CTCSS SET menu will appear.
Point the arrow at +MANUAL using the dial or
UP/DOWN key, and then press the
3
2
1
6
5
4
9
8
7
0
R
Select the reception frequency of CTCSS signal.
TF
key to complete the setting.
ENT
Note:
In the PMS or MR mode, when DIRECT WR is turned ON, this setting is
possible (the initial setting is ON). For further details, see "3.3.31 Directly
changing the settings" (page 63).
F
key, and then press
key with
shown on
9
C
TCSS MANUAL
O F F
ON
8 8 . 5 H z
TF
key.
ENT
Advertisement
Table of Contents
