Table of Contents
Advertisement
3.1.9 Displaying battery voltage
The battery voltage can be displayed as follows:
1
Call up the BATT VOLT screen.
3
2
1
Note:
• The measured value is updated every 0.5 second.
• If an external power source (10-16 V) is used, "OVER 8V" is displayed.
3.1.10 Setting the reception tone
The reception tone can be set to either of 2 levels as follows:
1
Call up the TONE screen.
3
2
1
2
Set the reception tone.
Point the arrow at High or Low using the dial or UP/DOWN key, and then press
TF
the
key (the initial setting is High).
ENT
The display will return to the CONFIG menu. Point the arrow at END and then
TF
press the
key (Alternatively, you may press the
ENT
key with
TF
ENT
Note:
If you exit the CONFIG menu by pressing the
is canceled.
Press the
F
key, and then
SET
press the
key with
HELP
shown on the display.
The BATT VOLT menu will
appear. Point the arrow at +CONFIG using the dial or
UP/DOWN key, and then press the
CONFIG menu will appear. Point the arrow at +BATT
VOLT using the dial or UP/DOWN key, and then press
TF
the
key.
ENT
The battery voltage will be shown on the display.
If you press the
disappears.
F
Press the
key, and then press
SET
the
key with
HELP
the display.
The TONE menu will appear.
Point the arrow at +CONFIG using the dial or UP/DOWN
key, and then press the
The CONFIG menu will appear. Point the arrow at
+TONE and then press the
shown on the display).
TF
ENT
SKIP
key, the battery voltage
CLR
shown on
TF
key.
ENT
TF
key.
ENT
key, and then press the
F
SKIP
key, the changed setting
CLR
4 . 9 V
key. The
TONE
H i g h
L OW
39
Advertisement
Table of Contents
