Table of Contents
Advertisement
2
Point the arrow at the desired option using the dial or UP/DOWN key, and then
press the
• Starting the Flash tune
50
Select the Flash tune.
TF
key (the initial setting is F TUNE).
ENT
F TUNE
Instantaneously checks for a radio frequency and
automatically tunes in to the detected frequency.
F COUNTER
Check for a radio frequency and shows the detected
frequency in real time (the frequency resolution is
100 Hz).
Press the
tune will start.
Pressing the
3
2
1
6
5
4
9
8
7
0
CL R
Note:
• The operating frequencies in the F TUNE and F COUNTR modes ranges
from approximately 50 MHz to 1300 MHz. The Flash tune starts with input
of approximately -30 dB or more. However, if there is any strong radio or
noise than the targeted radio, the Flash tune may not be activated
depending on the frequency condition.
• This function is not applicable to intermittent radio in intervals of 0.1 second
or less, such as digital radio.
• The Flash tune is not valid for radio that fluctuates by 1 kHz or more.
• If the Flash tune is set during scanning in the PMS or MR mode, the
scanning is canceled.
key, and then press the
F
shown on the display. The Flash
SKIP
key cancels the Flash tune.
CLR
F TUNE
key with
Advertisement
Table of Contents
