Alinco DJ-X2000 Instruction Manual page 60

Wide range scanning receiver
Hide thumbs Also See for DJ-X2000:
Table of Contents

Advertisement

3
To stop the recording, press the
To pause (temporarily stop) the recording, press the
F TUNE
When the recording time reaches 160 seconds, "END" appears on the display
and the recording stops automatically.
4
Press the
• Playing back the recorded sound
1
2
Press the
elapsed time will appear on the display.
3
To stop the playback, press the
To pause (temporarily stop) the playback, press the
If you press the
After all the recorded sound has been played back, "END" appears on the
display and the playback stops automatically.
4
Press the
58
Stop or pause the recording.
key again, the recording is resumed.
Exit the recording mode.
SKIP
key.
CLR
Note:
• Only a single session of sound can be recorded.
• No other function can be used during the recording.
• The sound volume can be controlled in the recording mode.
• Sound can be repeatedly recorded approximately 10,000 times.
• The RX AF recording starts when sound signal is received.
Call up the recording screen.
Press the
the
the display.
The recording screen will appear.
3
2
1
6
5
4
9
8
7
0
CL R
Start the playback.
ATT
key. The playback will start and the
3
Stop or pause the playback.
F TUNE
key again, the playback is resumed.
Exit the recording mode.
SKIP
key.
CLR
Note:
• No other function can be used during playback.
• No battery backup is required to store the recorded data.
• If the all reset function is used, the recorded data is erased.
STEP
key.
2
F
key, and then press
REC
key with
shown on
0
STEP
key.
2
F TUNE
key. If you press the
1
2
3
.
F TUNE
key.
L
5 s

Advertisement

Table of Contents
loading

Table of Contents