Table of Contents
Advertisement
3.1.24 Descrambler
This function descrambles the scrambled voice signals.
Note:
Only the NFM type radio signals can be descrambled.
1
Call up the SET SCRAMBLE screen and then turn ON the
Descrambler.
3
2
1
6
5
4
9
8
7
0
R
2
Control the carrier.
With the arrow pointing at ON, set the carrier to the state where the voice can be
recognized. The carrier can be increased or decreased in a range between 0
and 125 (the initial setting is 40).
If you press the
appears with the Descrambler being active.
• Canceling the Descrambler
SKIP
Press the
key. This will cancel the Descrambler.
CLR
• Priority in comparison with the CTCSS decoding function and A/B squelch
The Descrambler cannot be used with the CTCSS decoding function or A/B
squelch.
• If the A/B squelch is turned ON when the Descrambler is active, the A/B
squelch takes priority.
• The CTCSS decoding function cannot be used when the Descrambler or A/B
squelch is active.
• If the Descrambler is turned ON when the CTCSS decoding function is active,
the CTCSS decoding function remains disabled until the Descrambler is turned
OFF.
Note:
• If you press the
Descrambler is active, the Descrambler is disabled for any radio type other
than the NFM.
• If "VOL" is blinking on the display when the Descrambler is active, the
sound volume can be controlled.
Press the
F
key, and then press
SCRT
the
key with
7
the display.
The SET SCRAMBLE screen will
appear. Point the arrow at ON using the UP/DOWN key.
TF
key with the arrow pointing at ON, the normal screen
ENT
TF
key to display the normal screen when the
ENT
shown on
O F F
ON
4
51
Advertisement
Table of Contents
