Table of Contents
Advertisement
3.2 Functions in the VFO mode
This section describes various functions available in the VFO mode.
3.2.1 VFO link function
This function is used to synchronously change two VFO frequencies, the
currently received frequency and another frequency.
1
Call up the LINK SET screen.
CL R
2
Select a type of the VFO link function.
Point the arrow at the desired option using the dial or UP/DOWN key, and then
press the
AUTO LINK
USER LINK
LINK OFF
Note:
Specify frequencies in bands A
and B of VFO.
Press the
SKIP
the
CLR
the display.
3
2
1
6
5
4
9
8
7
0
TF
key (the initial setting is LINK OFF).
ENT
The frequencies in bands A and B interlock and change
at the interval that was set using the auto link function.
Both bands A and B are displayed in capital letters and
the VFO link function becomes active. As the frequency
on the upper line of the display is changed, the one on
the lower line changes simultaneously.
The VFO link function is canceled.
The frequency on the upper line may exceed 2149.999950 MHz (the upper
limit for the DJ-X2000) when it is changed. In this case, press the
toggle between bands A and B. The band shown on the upper line will be
switched to the lower line. The band shown on the lower line (exceeding
2149.9999 MHz) will be included in a range between 0.1 MHz and
2149.999 MHz and then switched to the upper line while maintaining the
difference between the two frequencies. The VFO link function is not
canceled.
key, and then press
F
key with
shown on
L I NK SET
AU T O L I NK
US ER L I NK
VFO
A=B
key
63
Advertisement
Table of Contents
