Table of Contents
Advertisement
9. Useful Functions
9-2 Scanning Function
The Scan function automatically changes the frequencies and searches for
signals being sent.
The following scan types are available.
VFO scan
Preset scan
Memory scan
Programmed scan
MEMO
9
● Operations common to all scan types
• Scanning stops when any one of the ［ FUNC ］ ,
• The scanning direction can be changed by rotating the dial during
scanning.
• When the Monitor function is used, scanning is suspended to open the
squelch temporarily. Releasing the Monitor function resumes scanning.
• Scanning starts in the direction of the last scan. (Programmed scan,
however, starts scanning from
• You can specify conditions to resume scanning. For the setting
procedure, refer to "Scan mode setting" (P. 88).
9-3 VFO Scan
Press the
1
Hold down the
2
lect "VFO scan".
Release the
3
During scanning, the decimal point of the displayed frequency fl ashes.
Press the [FUNC] or
4
stop scanning.
64
• The programmable items shown in P.35 with
tions while programmed scannintg, but setting such as tone-squelch
and modulation mode must be completed in VFO mode, and VFO pa-
rameters are always respected for programmed scan.
key to switch to VFO mode.
In VFO mode, the scan searches all frequencies
within the selected band by using the tuning step
specifi ed in advance.
The scan searches the frequencies within the band
specifi ed in Preset mode.
In memory mode, the scan searches for only
frequencies which have been programmed in the
memory.
The scan searches a range of frequencies between
upper and lower limits which can be set by the user
in advance.
A to
key and rotate the upper dial to se-
key to start scanning.
key to
do not affect their func-
keys is pressed.
b.)
145.000
VFO
VFO scan
B S
F M
Advertisement
Table of Contents
