Table of Contents
Advertisement
• Meter display mode
1
2
As the electric field strength increases, the S-meter
shows higher levels with faster beeping.
• Set level mode:
1
2
Set the level by selecting a number from 1 through 9 (the
initial setting is 3) using the dial, the UP/DOWN key, or a
numeric key.
When the electric field strength exceeds the set level, the buzzer sounds with
{bell icon} blinking on the display. The buzzer sounds for 10 seconds and {bell
icon} continues to blink.
• Canceling the set level mode
If you press the
If
38
Call up the CHECKER screen.
Press the
menu will appear. Point the arrow
at CHECKER using the dial or
3
2
1
UP/DOWN key, and then press the
6
5
4
TF
9
key.
ENT
8
7
0
C L R
Measure the electric field strength.
Note:
Since the electric-field meter is intended to measure the nearby strong
electric field strength, it reacts at the sensitivity of approximately -50 dBm
minimum. The sensitivity varies depending on the frequency.
Call up the CALL WAIT screen.
Press the
CHECK menu will appear. Point
the arrow at CALL WAIT using the
3
2
1
dial or UP/DOWN key, and then
6
5
4
press the
9
8
7
0
C L R
Set up the set level mode.
SKIP
key when
CLR
is not blinking, pressing the
Note:
In the set level mode, only the POWER switch and
M NAME
. The RF CHECK
RFC
M NAME
key. The RF
RFC
TF
key.
ENT
is blinking, this blinking stops.
SKIP
M NAME
or
key cancels this mode.
CLR
RFC
RF
R F
RF
R F CA L L L V L 3
LAMP
key are valid.
Advertisement
Table of Contents
