Table of Contents
Advertisement
• To tune in live frequencies
• To cancel the search
Press the
2.9 Monitoring (Squelch OFF)
The monitor function is used to pick up weak signals .
• To turn the monitor ON
• To keep the monitor ON at all times
24
To move live frequencies to the left,
turn the dial clockwise or press the
UP key. To move them to the right,
turn the dial counterclockwise or
press the DOWN key.
SRCH
key again. This will cancel the search.
Note:
• For specifying search steps and search resuming conditions, see "3.1.22
Specifying search resuming conditions" (page 49).
• The search resume condition factory-setting is INTERVAL. Sound is muted
during the search. The search operation is performed every 10 seconds.
• It may be difficult to read a value from the S meter during scanning in the
Channel Scope mode, because the speed is fast.
• The graph displayed in the Channel Scope mode is only in the range of the
currently received radio type. For example, if search is performed around
76.5 MHz of WFM, no channel for less than 76.0 MHz, which is of NFM, is
not displayed.
• If the Channel Scope mode is selected, the battery saving function is
disabled.
• If the search function is turned ON in the MR mode, it may take some time
for the full display of search.
• If scanning is started with the search function turned ON, it may take some
time to start scanning.
Hold down the
the squelch is turned OFF and weak signals can be picked
up . (Noise is heard if no signal is being received.)
When the
ON and the DJ-X10 returns to its original state.
Press the
The squelch will remain OFF even after the
been released. Pressing the
second time will reactivate the squelch.
MONI
key. The duration the key is depressed,
MONI
key is released, the squelch comes back
key to display
F
MONI
W
FM
A
8 1 . 5
b
1 4 5 . 3 4
MONI
, followed by the
key.
MONI
key has
key a
Advertisement
Table of Contents
