Table of Contents
Advertisement
3.1.4 Battery Save
When ON, the battery-save feature automatically saves on battery power
whenever keys are not used or a signal is not picked up for a certain amount of
time.
1
2
Point the arrow at the desired ON/OFF ratio using the dial or UP/DOWN key, and
then press the
The display will return to the CONFIG menu. Point the arrow at END and then
press the
the
34
Note:
• The attenuation level slightly varies depending on the frequency.
• In the PMS or MR mode, setting DIRECT WR to ON enables selection of a
frequency step and radio type and adjustment of the attenuator and CTCSS
decoders. For further details, see "3.3.31 Directly changing the setting"
(page 63).
Call up the BATT SAVE screen.
Press the
the
HELP
the display.
The menu will appear. Point the
arrow at +CONFIG using the dial or UP/DOWN key, and
then press the
3
The CONFIG menu will appear. Point the arrow at +BATT
2
1
6
5
4
SAVE and then press the
9
8
7
0
C LR
Select an ON/OFF ratio for the battery saving feature.
TF
key (the initial setting is NORMAL).
ENT
TF
key (Alternatively, you may press the
ENT
TF
key with
appearing on the display).
ENT
Note:
• If you exit the CONFIG menu by pressing the
setting will be canceled.
• If LONG is selected, the time to keep the internal power source OFF
becomes longer. This extends the battery life, but delays the receiving
reaction.
F
key, and then press
SET
key with
appearing on
TF
key.
ENT
BATT SAVE
O F F
SHOR T
TF
key.
ENT
key, and then press
F
SKIP
key, the changed
CLR
Advertisement
Table of Contents
