Table of Contents
Advertisement
Note:
• The cloning procedure or communication with a personal computer is not
possible between DJ-X2000 units with different communication speeds.
• The initial value is a high speed of 38400 bps. If there are too many
communication errors at this speed, retry the communication at a lower
speed, e.g., 9600 bps.
3.1.7 Selecting a language mode
The DJ-X2000 was set to the English mode at factory, but may be changed to
the English mode.
1
Call up the LANGUAGE screen.
3
2
1
6
2
Select a language mode.
Point the arrow at English or Japanese using the dial or UP/DOWN key, and
TF
then press the
ENT
The display will return to the CONFIG menu. Point the arrow at END and then
TF
press the
key (Alternatively, you may press the
ENT
TF
the
key with
ENT
Note:
If you exit the CONFIG menu by pressing the
is canceled.
3.1.8 Field-strength meter
The level of the aperiodic field-strength meter can be set. When the electric field
strength reaches the set level, the buzzer sounds. This feature can be used,
e.g., to check for transmission from a bug.
The DJ-X2000 provides the following two modes to show electric field strength:
Meter display mode
Set level mode
Press the
F
key, and then
key with
shown on the display.
The LANGUAGE screen will
appear. Point the arrow at
+CONFIG using the dial or
UP/DOWN key, and then press the
The CONFIG menu will appear. Point the arrow at
+LANGUAGE and then press the
key (the initial setting is English).
shown on the display).
Shows changes in electric field strength using
the S-meter and beep sound.
Starts sounding the buzzer when electric field
strength reaches the set level.
SET
HELP
LANGUAGE
J a p a n e s e
E n g l i s h
TF
key.
ENT
TF
key.
ENT
key, and then press
F
SKIP
key, the changed setting
CLR
37
Advertisement
Table of Contents
