Resetting The Receiver - Alinco DJ-X2000 Instruction Manual

2
Enter a message.
Select each character by turning the dial, and then establish it by pressing the
DOWN key. Pressing the UP key allows you to cancel the established character.
Up to 36 characters may be entered (the initial setting is ALINCO INTELLIGENT
RECEIVER).
3
Finish the setting.
After you have finished entering the characters, press the
The display will return to the CONFIG menu. Point the arrow at END and then
TF
press the key (Alternatively, you may press the
ENT
TF
key with
ENT
Note: • If you exit the CONFIG menu by pressing the
setting is canceled.
• If you turn the dial while holding down the
characters ahead.

3.1.13 Resetting the receiver

This command resets the DJ-X2000. Be careful as all settings you made up till
now may be cleared from memory, depending on your selection.
CANCEL
SYSTEM
ALL
CAUTION:
shown on the display.
While holding down the
turn ON the power. When the DJ-
X2000 starts up, the USER RESET
menu will appear on the display.
Move the arrow to the reset command you want, using
the dial or the UP/DOWN key. Then, press the
Reset commands are described here following.
Cancels the reset command entirely.
Initializes user-set functions, but it does not clear memory
channels. (Choose this normally.)
Clears all functions and memories including factory-set
bandplan.
It takes time to complete the resetting. Do not turn ON the power
during the resetting.
TF
key.
ENT
key, and then press the
F
SKIP
key, the changed
CLR
key, you can move 11
F
key,
F
USER RESET
CANCE L
S Y S T EM
TF
key.
ENT
41