Table of Contents
Advertisement
2
Using the dial or UP/DOWN key, point the arrow at a desired mode, and then
press the
The display will go back to the CONFIG menu. Point the arrow at END, and then
press the
key with
2.11 Turning beep ON/OFF
The beep sound that is emitted when a key is pressed or a specific operation is
performed can be turned ON/OFF and its volume can be controlled as follows:
1
2
Using the dial or the UP/DOWN key, point the arrow at a desired mode, and then
press the
The display will go back to the CONFIG menu. Point the arrow at END, and then
press the
key with
26
Select a backlight mode as follows:
TF
key (the initial setting is the MOMENTARY mode).
ENT
AUTO:
The backlight is lit for 5 seconds after the dial or key is
used.
MOMENTARY: The backlight remains lit only while the
held down.
ALTERNATE:
The backlight is turned alternately ON and OFF every time
LAMP
the
TF
key (or alternatively, press the
ENT
shown on the display.
Note:
If you exit the CONFIG menu by pressing the
setting is canceled.
Display the BEEP screen.
Press the
the
the display. The menu will
appear. Using the dial or the
UP/DOWN key, point the arrow at +CONFIG, and then
press the
Point the arrow at +BEEP, and then press the
3
2
1
6
5
4
9
Select a beep sound mode.
TF
key (the initial setting is the HIGH mode).
ENT
OFF:
The beep sound is turned OFF.
The beep sound is emitted at a high level.
HIGH:
LOW:
The beep sound is emitted at a low level.
TF
key (or alternatively, press the
ENT
shown on the display).
Note:
•If you exit the CONFIG menu by pressing the
setting is canceled.
• If stereo earphones are used, the beep sound can be heard from the left
earphone only.
key is pressed.
key, and then press the
F
key, and then press
F
SET
key with
shown on
HELP
TF
key. The CONFIG menu will appear.
ENT
key, and then press the
F
LAMP
key is being
TF
ENT
SKIP
key, the changed
CLR
BEEP
H i g h
L OW
key.
TF
ENT
TF
ENT
SKIP
key, the changed
CLR
Advertisement
Table of Contents
