Remote Program ? (Command + 4 + 3) - Bosch D1260 Owner's Manual

REMOTE PROGRAM ? (COMMAND + 4 + 3)

Description
This function allows the user to initiate Remote Account Manager sessions. When the phone is ringing at the panel, the
user initiates this function to have the panel seize the line.
Your security company can remotely program your security system using the telephone line to which your panel is
connected. Typical remote programming functions include: changing personal passcodes, changing entry/exit delays,
resetting the system clock/calendar, and adding/deleting system arming commands.
Your security company may ask you to follow the steps below to begin a remote programming session. The time it takes
to program the panel is dependent on the number of changes made to the program.
You'll notice that two sets of procedures are presented. The one you use will depend upon whether your system has a
pre-programmed telephone number in its memory.
For systems without a phone number
1. Ensure your command center shows idle disarmed
text.
2. Call this phone number:
This number is designated for the Remote Account Manager.
You must make the call using the telephone located at:
3. Identify yourself and your premises (account number, name, address, etc.) and advise the operator
of the services you wish to have performed. When the operator instructs you, proceed to steps 4 and
5.
4. Press the COMMAND key.
The display shows *System Command*.
5. Press the 4 key then the 3 key.
Do not hang up the telephone.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the REMOTE PROGRAM ?> prompt and press
the adjacent soft key.
6. The display changes to show the two choices that are
available for connecting to RAM:
•
Answer Now
•
Contact RAM: RAM via phone or network
© 2003 Bosch Security Systems
REMOTE PROGRAM ? (COMMAND + 4 + 3)
My system has a phone number
My system does not have a phone number
D1260 Owner's Manual
Part III: Advanced Commands
50410C