Chg Skeds ? (Command + 5 + 2) - Bosch D1260 Owner's Manual

CHG SKEDS ? (COMMAND + 5 + 2)

Description
A Sked is a function programmed to be performed automatically at a scheduled time by your security system. You can
change the scheduled time for some functions, disable the Sked and thus prevent it from automatically happening or
restart a previously disabled Sked. Contact your security representative to determine what Skeds may be programmed for
your system.
To change a Sked's time, enable a Sked, or disable a Sked, follow the procedure below to first select the Sked from a list of
Skeds programmed for your system.
Using Chg SKEDS
1. Ensure your command center shows idle disarmed
text.
2. Press the COMMAND key.
3. The display shows *System Command*.
4. Press the 5 key and then the 2 key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the CHG SKEDS ?> prompt then press the
adjacent soft key.
5. The number of the first Sked programmed into your
system is displayed, plus either its time or an
indication that it is disabled.
Press the Next> soft key to scroll through the list of
Sked numbers to find the one you wish to change.
Your alarm system may be programmed with up to 40
Skeds. If the Sked number being displayed is not
programmed, the command center will display Skd11
– No program. (11 is used as an example)
When an X appears in the Sked display, it is an
indication that "Except on Holidays" is enabled.
Specific holidays are programmed by your security
company.
When an * appears in the Sked display, it is an indication that the Sked has or will happen today.
© 2003 Bosch Security Systems
Part III: Advanced Commands
CHG SKEDS ? (COMMAND + 5 + 2)
D1260 Owner's Manual
50410C