Bypass A Point? (Command + 0) - Bosch D1260 Owner's Manual

BYPASS A POINT? (COMMAND + 0)

Description
This command allows you to bypass points that you do not want included in the system. Points that are not included in
the system do not detect intruders and cannot send any reports. You can bypass points when an area is disarmed.
Bypassing a point reduces the level of security and should be used with discretion. Points remain bypassed until you
unbypass them or some points may return when the area is disarmed. See Unbypassing a Point (COMMAND 00).
You could use COMMAND 0 to leave a window open over night without initiating an alarm. Also see Turning the System
On With Doors or Windows Open.
Using Bypass a Point
1. Ensure your command center shows idle disarmed
text.
2. Press the COMMAND key.
3. The display shows *System Command*.
4.
Press the 0 key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the BYPASS A POINT ?> prompt then press the
adjacent soft key.
5. You will prompted for your passcode. It will appear on
the display as asterisks (*).
6. The display changes to show Enter point number or
press next key.
7. If a digit is pressed, the display shows Enter point
number: #. As soon as a digit key is pressed, the display
changes to Entering point number:.
(# is the point number entered)
If you know the point number you wish to bypass,
enter the number and press the Enter> soft key
© 2003 Bosch Security Systems
Part III: Advanced Commands
BYPASS A POINT? (COMMAND + 0)
D1260 Owner's Manual
50410C